Forum .LRN Q&A: Re: How to configure ns_senmail

Collapse
2: Re: How to configure ns_senmail (response to 1)
Posted by Emmanuelle Raffenne on 08/12/09 11:36 AM
Hi Fernando,

What version of dotLRN are you using?

In any case, until dotLRN 2.4, emails are sent out using the smtp library and in very few cases ns_sendmail. As of upcoming version 2.5.0, ns_sendmail won't be used anymore.

smtp is configures in the parameters of the acs-mail-lite package. Go to the site-wide admin pages (http://yourserver/acs-admin), click on "parameters" next to "ACS Mail Lite" and edit the parameters under the "SMTP" section of the form.

ns_sendmail is configured in the config.tcl file. I'm not sure on how to configure the mail server port there though.

In any case, I would recomend that you replace calls to ns_sendmail with ones to acs_mail_lite::send

Collapse
3: Re: Res: Re: How to configure ns_senmail (response to 2)
Posted by Fernando Jose Ernesto Mendoza Jerez on 08/12/09 06:18 PM
Hi Emmanuelle

i check the config parameter for ACS Mail Lite but the version is 0.6a very old and dont have SMTP section. And i nedd connect to my smtp with SSL.

Collapse
4: Re: Res: Re: How to configure ns_senmail (response to 3)
Posted by Emmanuelle Raffenne on 08/12/09 07:50 PM
Fernando,

I found the following at the AOLserver doc (http://aolserver.com/docs/devel/tcl/api/general.html#ns_sendmail):

<q>ns_sendmail uses the SMTP server specified by the MailHost parameter in the configuration file. If MailHost is not specified in the configuration file, localhost is used. You can also specify an SMTP smarterhost in the SmtpPort parameter in the configuration file. </q>

Since "mailhost" parameter is in the ns/parameters section, I guess you need to add the "SmtpPort" in the same one.

Hope that will work.